Where does fiber optic cable go after installation?

The next step usually takes place about 2 weeks later. We complete the construction process by feeding the fiber optic cable through the conduit already on your property. Then, we connect the cable to a weather-proof box that we will fasten to the outside of the house. The box usually goes next to your electrical meter.

Where to plug in at & T fiber cable?

CAUTION: Do not look into the end of the fiber connector as this can cause eye damage. Plug the red ONT Ethernet cable into the service box Ethernet port. Plug the black power cord into the service box and an electrical outlet. Make sure the ON/OFF button is pressed in.

How long does it take to install at & T fiber?

Fiber services require full fiber networking, and the technician will upgrade all of your lines to be sure you have the most up-to-date fiber technology. AT Fiber takes from 4-6 hours to be fully installed. This includes replacing existing copper wiring with new fiber lines. This provides you with the best Internet experience.

Where do I plug in the green fiber cable?

Plug the green fiber connecter to the green PON port (if not already connected). CAUTION: Do not look into the end of the fiber connector as this can cause eye damage.

How will I be connected to the fiber optic line?

An Ethernet jack will be installed at the location where the gateway is to be placed. Once your gateway is powered up (BGW210-700), within a couple of minutes you will have a 1000Mbps connection. The AT gateway is very new and will provide excellent wireless coverage (b/g/n/ac.) The gateway itself has 4 1GB Ethernet ports.

CAUTION: Do not look into the end of the fiber connector as this can cause eye damage. Plug the red ONT Ethernet cable into the service box Ethernet port. Plug the black power cord into the service box and an electrical outlet. Make sure the ON/OFF button is pressed in.

How does at & t bring fiber-optic internet into your house?

New single family home being built, got 3 ethernet CAT5 cables hanging outside of house (their other end go to 3 different Ethernet outlets in the house). How will AT bring fiber-optic internet into my house, and how does it work with the 3 ethernet cables hanging outside?? Thank you – VERY helpful!

How long does it take to install fiber optic cable?

Installation took about two hours. Typically the fiber optics stops at the VRAD you will be served out of. From there it will run over the existing copper cable pairs to your residence. Once at the residence it will typically be run on copper again using one of your existing phone jack cables.