How do I factory reset my DSC?

You can reset a DSC Impassa to factory defaults by first unplugging the AC transformer and disconnecting the battery to cut power. Then connect a jumper between inputs IO1 and IO2. Power up the panel, wait 10 seconds and power down. Then disconnect the jumper, and power the system back on.

How do I reset my DSC alarm code?

DSC alarms can go off for a number of reasons. To reset the alarm or the warning lights, enter your master code twice, press the reset button, and then enter “*72” if the alarm is still ringing. Once the alarm is off, try to find out why it went off.

How do I reset my alarm panel?

How Do I Reset My Alarm System?

1. Disconnect the backup battery. Open up the system, and disconnect the backup battery.
2. Unplug the transformer. Locate the transformer, and unplug it from the wall outlet.
3. Power on. Plug the transformer and the battery back in.

How do you clear the memory on a DSC alarm system?

To clear the memory, arm and disarm the system. Certain sensors (such as smoke detectors and glass break detectors) have to be reset after an alarm. To reset detectors, press and hold the RESET key () for 2 seconds.

What do I do if I forgot my alarm code?

Reset user code: Enter the master code and enter *5, then enter the 2-digit number for that. Now type a new user code. Enter your 4-digit code to silence the alarm. Enter your 4-digit code once again and press the “Reset” button to clear the system fault.

What is the default master code for DSC alarm?

1234
The default master code is 1234. The master code is automatically assigned to user number 40. The master code is the first user code that comes programmed on the panel and it cannot be deleted, but it can and should be changed. The master code allows you to do quite a few things on the alarm system.

How do you clear a DSC alarm?

How to Reset a DSC Alarm After the Power Has Been Off

1. Press and hold the “RESET” key for 2 seconds.
2. Press the buttons “*72” if the alarm does not reset after pressing the RESET button.
3. Check the sensors if it still does not turn off.

How do you clear the yellow light on a DSC alarm?

Press the ‘7’ key and you will receive a number corresponding to the affected zone. The indicated zone is reading a low battery condition and needs a replacement battery. Replace the battery in the contact and the condition will clear.

Can you reset an alarm without code?

Most home alarm systems and security cameras include instruction manuals and guided instructions for resetting systems without a readily available passcode. Because alarm systems differ, each set of instructions based on the make and model of your device is likely to vary.

Where is the reset button on a DSc alarm?

This button is usually located on the bottom right side of the keypad. Hold it down for at least 2 seconds to disengage the alarm. You will notice the lights on the alarm change from red to green to signal that the alarm has been reset. This also helps to reset the low battery light once the power has been restored.

Why does my DSC alarm keep ringing when no power is on?

This is the most common reason for DSC alarms to unexpectedly ring. Check if the lights on the property are working to ascertain if the power is currently on. If the power is out and the alarm is ringing, this indicates that the batteries in the alarm system are dead and need to be replaced.

What do you need to know about a DSc alarm?

Search the area for signs of an intruder. Your DSC alarm system is designed to alert you of unusual motion in and around your property. Check your property for any signs of intrusion, such as broken windows, stolen goods, and dirty footprints inside.